FlybackTransformerDriver

今天小编要和大家分享的是driver相关信息，接下来我将从flyback transformer driver，a taxi driver百度云 图片合集这几个方面来介绍。

driver相关技术文章flyback transformer driver

flyback transformer driver

general description and circuit operation:

this is an efficient flyback driver for modern cylindrical rectified television flybacks. many sites doesn't provide circuits driving these transformers, they simply say that they are bad.

i don't agree. in fact i built this circuit. i spent a lot of time for finding resonant frequency (around 15khz) and duty cycle. these transformers best work at around 90% duty cycle. you may notice corona breakdown at terminals and pfffff sound (as well as the ozone smell) when adjusting the off time trimmer to near 500-300 ohms. of course it will work for other tipes of flyback as frequency and duty cycle have a large range.

frequency range can be increased using multiposition switch for other values of c3 capacitor ,for example 2 nf for 80khz-200000khz, but didn't found flybacks with so high resonant frequencies, in addition with higher values of c3 , eg 200nf, 2uf the frequency will drop making possible the use of ignition coils, and rectified power transformers @50hz to charge high voltage electrolitic caps at 300-400v). unfortunately my ignition coil died because insulation breakdown (too long drawn arcs)...

i was able to power a small (20cm) spark gap tesla coil using these dc rectified flybacks to charge primary tank capacitor.

the operation is simple

the 555 is wired as an astable and the capacitor is charged only through the 4,7kohm trimmer (notice the diode) and discharged only through the 2.2 kohm trimmer, making the duty cycle full adjustable. the square wave is then feed in a totem pole made up of a 2n3904 and a 2n3906, which are cheap, and easy to find. the totem pole ensures the gate being charged and discharged very fast (approx 50ns i think). the irf840 is a cheap (i found it for 4euros) reliable and powerful power mosfet, it has current capability of 8 a continuous and 32a pulse, 800v drain source voltage, protecting internal zener diode.  there is a snubbing network to ensure that voltage spikes are kept low (unless the insulation of the  transformer start to leak) protecting both transistors and 555 ic. 100 ohm is a compromise between decay time and voltage spike.

comments and specifications:

the 100 ohm snubber must me a 5w resistor, or it will burn at long operationsthe led is only for safety purposesuse a dead man switch (pushbutton) for safetythe power supply must supply at least 2-3 a if you want decent arcs (20000 kv)

dangers:the flyback driven in this way can supply a significant current, aldough the heart fibrillation starts at 30mai recommend caution to avoid painful arc-burns.the arc is a hot plasma, never operate the circuit in presence of flammable substances.charging high voltage capacitors is a serious life threat, so if you arent unexperienced just draw arcs and no morethis device when rectified generates static voltage that can be a little annoying.... (or fun, i sprayed with coronaa plastic pen from positive terminal and then i was able to attract little pieces of paper)

disclaimer:i don't assume any responsibility of the damages or discruptions dove by this device, to persons or things. any irresponsable action would be a serios danger. this is high voltage threat it with respect.

关于driver就介绍完了，您有什么想法可以联系小编。